Motor Rotor Recycling Machines

● Before starting the machine, the surface of the scrap iron briquetting machine mold and column should be cleaned, and the column should be lubricated to check whether the liquid level of the hydraulic pump station is appropriate.
● Check whether there is oil leakage in the oil pipe, oil cylinder and hydraulic valve, and start the machine if there is no abnormality.

First, turn on the power switch, the power indicator light is on, press the "motor start" button, the motor starts, and the hydraulic pump is in the state of no-load cycle.

● The "Working state selection" switch is placed in the fully automatic state. At this moment, the equipment is in the automatic mode, and the production process generally uses the automatic mode.
● The raw materials are quantitatively transported into the material box, and the distribution oil cylinder pushes the material box to send the raw materials into the mold cavity;
● After being controlled by the control cabinet, the slider goes down quickly. After reaching the set limit, the slider goes down slowly, and the punch and the cavity are closed and pressurized;
● When the set time is reached, the slider moves upwards slightly, the push block cylinder retreats, the slider moves down, and the formed cake is pressed down;
● Push the block cylinder forward, push out the cake block, and continue to the next cycle

● Before shutting down, the raw materials in the material box and the mold cavity should be used up to prevent the mold from being stuck next time it is turned on;
● Lower the slider into the mold cavity, and then press the "motor stop" button to close the oil pump and the power switch.